0
You are here: Home Forum Using the Jaguarboard Beginners Installing Windows Embedded 8 Standard fails
Welcome, Guest
Username: Password: Remember me
Forgot your password? Forgot your username? Create an account
Forum
Using the Jaguarboard
Beginners
Installing Windows Embedded 8 Standard fails

TOPIC: Installing Windows Embedded 8 Standard fails

Installing Windows Embedded 8 Standard fails 6 years 5 months ago #644

  • rathapolk
  • rathapolk's Avatar
  • OFFLINE
  • New Member
  • Posts: 1
  • Karma: 0
Hi,

I have got JaguarBoard 2 weeks ago. It booted up and worked with pre-installed Fedora Linux.

I tried to install Windows Embedded 8 Standard (32-bit). I had successfully flashed the BIOS for 32-bit Windows. Then I ran the Windows installation to the end of the process. After restart, it showed Recovery screen with an error code 0xc0000001.

Does the board support this version of Windows? Or, are there anyway for troubleshooting? I am very new to Windows embedded.

Thank you,
Rathapol K
The administrator has disabled public write access.

Installing Windows Embedded 8 Standard fails 6 years 5 months ago #645

  • tim
  • tim's Avatar
  • OFFLINE
  • Moderator
  • Posts: 226
  • Thank you received: 30
  • Karma: 4
Hi Sir,

We only tested windows 8 or 10 32 bit system, not Embedded one.
The administrator has disabled public write access.
Forum
Using the Jaguarboard
Beginners
Installing Windows Embedded 8 Standard fails
Time to create page: 0.035 seconds
Powered by Kunena Forum